Baby Unit - miniland baby digitalk premium Manual De Instrucciones

Your Baby Monitor is supplied with 2 x AAA 1.2V
750mAh Ni-MH rechargeable batteries for the parent
unit. We recommend the use of the batteries in the pa-
rent unit to be able to listen to the baby unit from any
location. Reconnect the parent unit to the adaptor whe-
never possible to keep the battery charged up.
Main steps:
- Remove the battery cover on the back of the
parent unit by applying pressure and sliding it down.
Insert the rechargeable batteries as marked on the
unit and close the cover again.
- Place the parent unit into the charger pod.
- Plug the mains adaptor into a mains power socket.
The red LED (7) flashes. (LED is steady when power
is on and flashes during recharging of the batteries).

Baby unit:

The baby unit of this baby monitor is designed to be
powered by either batteries or the provided AC/DC
adaptor. The batteries are for backing up the baby
unit during a power failure. It is therefore
recommended that you insert non-rechargeable
batteries in the baby unit.
Main steps:
- Unscrew and remove the battery cover on the back of the prent unit.
- Insert 4 AAA alkaline batteries (not included) and close the cover again.
Do not use rechargeable batteries in the baby unit.
- Plug the power cord into the power input at the bottom of the baby unit and plug
the adaptor plug into a mains power socket.
- Press and hold down the Power Key to turn the baby unit on if necessary.
The LED (14) will be ON (if night light is set ON).
5.2. OPERATION:
Once you have set up your Baby Monitor, you will be able to hear the sounds in
your baby's room through the Parent Unit. You will also be able to see the sound
level LED, which flashes faster if the volume increases, and more slowly if the
volume decreases.
27
1
2