Out Of Range Warning - miniland baby digimonitor 3.5 plus Manual Del Usuario

en
5.2.4. ZOOM
You may increase the size of the image viewed, carrying out a four-position zoom.
Press the zoom/menu button (8) to access the zoom function
The upper left quarter of the image will appear in the white section
Press the set buttons ▲ (7) or ▼ (9) to change the selected quarter.
Press the remote/accept button (10) to increase the image of the selected quarter.
Press the zoom/menu button (8) and you will return to the quarter selection process in case
you wish to zoom onto another of the quarters.
Press the zoom/menu button again (8) to exit the zoom function.
5.2.5. PAIRING
This product is designed to allow the observation of different areas with up to 4 cameras
(channels 1, 2, 3 or 4 assigned to different cameras). The monitor and the original camera
leave the factory with channel 1 programmed. If you need to add an extra camera, follow
the process set out below.
Keep the baby talk button (11) and the set button ▲ (7) pressed simultaneously until the
LED flashes. Then press the link button (V) of the camera. When you release the camera
button, the pairing process has finished and you should be able to clearly observe the
image captured by the camera on the monitor.
For various reasons you may lose the connection between the monitor and a camera which
is already connected. Should this be the case, repeat the process explained above to
connect the camera with the monitor again.
5.2.6. INFRARED NIGHT VISION (AUTOMATIC)
The infrared night vision function enables the camera to capture images of your baby or of
the monitored area when it is dark or there is little light.
In this mode images will only be shown on the monitor in black and white and you will only
be able to see images situated less than 2 metres away.
The camera constantly monitors the light level and automatically switches to infrared mode
when there is not enough light for normal vision.

5.2.7. OUT OF RANGE WARNING

If the monitor is located at a distance away from the camera which is greater than that
allowed (see the technical characteristics), the on/link LED indicator of the camera (VII)
and the monitor (2) will flash red, the coverage symbol (d) will appear red and the screen
will display the message "NO SIGNAL".
Bring the monitor closer to the camera to see the image correctly again.
5.2.8. MAIN MENU
Keep the zoom/menu button (8) pressed in order to make adjustments to the main
functions and characteristics of your baby monitor.
5.2.8.1. CHOOSING THE CAMERA AND SCAN MODE
This baby monitor allows up to 4 cameras to be linked to the same monitor. To choose the
camera from which you wish to view the image at this time, using the buttons ▲ (7) and ▼
(9) choose the camera selection icon (f) and press the remote/accept button (10) to
confirm. Using the buttons ▲ and ▼ again, choose from between the four cameras the one
you wish to view and press the remote/accept button (10) again to confirm the selection.