Installing The Belt Clip; Installing The Supplied Speaker/Microphone; Buttons, Knobs And Functions - Albrecht Tectalk Worker Manual Del Usuario

INSTALLING THE BELT CLIP

If the belt clip is not installed, its mounting location may get hot
during continuous transmission or under heated environment.
INSTALLING THE SUPPLIED
SPEAKER/MICROPHONE
Insert the speaker/microphone plugs into the speaker/ mic
sockets of the transceiver.
NOTE:
The transceiver is not fully water resistant when using external
speaker/microphone. Insert rubber cover to the sockets if the
external headset is not used. Other microphones may be used
as well, please make sure to use only accessory items with
"Kenwood"-style wiring.

BUTTONS, KNOBS and FUNCTIONS

A. Led Indicator — The LED lights continuously red while transmitting. The LED will be green
while in reception mode.
B. Channel Switch — Rotate to select the channel between CH 1 and 16. Channels are factory
pre-programmed and can be modified by PC programmer (ask service engineer or distributor)
3