Additional Functions - Albrecht Tectalk Worker Manual Del Usuario

ADDITIONAL FUNCTIONS

SQUELCH LEVEL
The purpose of Squelch is to mute the speaker when no signals are present (Squelch OFF). With
the squelch level correctly set, you will hear sound only while actually receiving signals (Squelch
ON). The squelch level can be adjusted via PC programming software (ask service technician or
distributor).
TIME-OUT TIMER (TOT)
The purpose of the Time-out Timer is to prevent any caller from using a channel for an extended
period of time which will cause thermal damage or may disturb other channel users. The built-in
Time-out Timer limits each transmission time to a certain time. When the transmission time
exceeds the timer you set, an alert tone will sound (timing depends on PC programming). Then
you have to release the PTT and are able to transmit again. Per default the Time-out Timer is set
to 5 minutes.
SCAN
Scan may be useful for hands-free monitoring of several frequencies. Scan function is only
possible when enabled by PC software by service technician or distributor.
•
The transceiver stops scanning at the frequency (or memory
channel) where a signal is detected. It then continues or stops
scanning.
•
lf there are less than 2 channels programmed, it can not scan.
•
On channel 16, press PTT and MONI key, it will turn on SCAN,
or turn off the SCAN.
VOICE Announcement
•
Voice Announcement ON/OFF can be set via PC software.
•
On channel 10, press PTT and MONI key, then switch on the transceiver, Voice Prompt
can be cancelled or activated.
•
On channel 15, press PTT and MONI key, then switch on the transceiver to choose
different voice prompt languages.
VOX (Voice Operated Transmission)
VOX eliminates the necessity of pressing the PTT each time you want to transmit. The transceiver
automatically switches to Transmission Mode when the VOX circuitry senses that you have
started to speak into the microphone.
•
When operating the VOX function, you can set the VOX Gain level which allows the
transceiver to recognize the sound levels. This can be done via the programming
software
5