Button 1. Ms (Memory Save) And Ml (Memory Load) Functions; Memory Programming Memory Save "M1 To M5; Memory Recall "M1 To M5; Button 2: Scan Functions - Albrecht AE2990 AFS Manual De Instrucciones

Button 1. MS (Memory Save) and ML (Memory Load) Functions:

This feature allows the user to save and recall specific frequency and operating mode. See
Memory programming and Recall instructions.

Memory Programming Memory Save "M1 to M5"

•
Using "UP/DOWN" buttons select the desired frequency and mode to be saved.
•
Press and release "FUNC" button and then press the "ML/MS" button, notice the
"M "icon blinking on the right side on the display.
•
Then press "SCAN/M/SCN" button to save in memory M1.
•
Repeat procedures 1and 2 and save it to "MODE / H/L" button for memory M2,
•
"STEP / CH/FREQ" button for M3, "CH9/19 / LOCK" button for M4 and "
SQ,MICG,RFG /RPT" for M5.
Now You will use the Memory Load ML function: See Memory Save MS in last paragraph.
•
Press ML/MS button and then SCAN / MSCN to recall memory M1
•
Press ML/MS button and then MODE / H/L to recall memory M2
•
Press ML/MS button and then STEP/ CH/FREQ. to recall memory M3
•
Press ML/MS button and then CH9/19 / LOCK to recall memory M4.
•
Press ML/MS button and then SQ, MICG, RF-G/ RPT to recall memory M5.
SCN (Scan) : Allows the radio to automatically scan through all frequency, stopping at any
frequency that is busy with signals being communicated. It will remain on that frequency
during the conversation, and will not reactivate scanning until roughly 5 seconds after the
communication signal has ended. To activate, press the "SCN/M/SCAN" button. The word
SCAN will appear on the display. To stop, press the "SCN/M/SCAN" button again.
M/SCAN (Memory Scan): This feature allows the user to scan all the 5 saved channels to
the memory. To Turn it "on", press the "FUNC" button first and then followed by the
"SCN/M/SCAN" button. To Turn-Off: Performed same procedure as mentioned above.
Shift-Offset Frequency: To access press the "SCN/M/SCAN" button for 3 seconds or
more, the shift frequency will appear on the display, then use the "up" and "down" button to
select the desired shift frequency from 0 to 990 KHz. This function can only be activated
when the unit is in Ham Radio mode. In CB, this function is not possible (and not needed at
all).
Allows selection between the four operational modes of the radio (AM/FM/USB/LSB). To
select your desired mode, press the "Mode" button until you see the mode in which you
desired. The order of appearance is FM then AM, then USB, and then LSB.
FM means Frequency modulation, this is the standard mode all over Europe, which is
allowed in all countries.
AM means Amplitude modulation, which is used by most truck drivers in continental Europe.
In SSB (Single Side Band) you will have the Upper Side Band USB and the Lower Side
Band LSB. SSB is the mode for the longest possible communication distances. All

Memory Recall "M1 to M5"

Button 2: Scan Functions

Button 3. Mode switch

21