Led Indicators For Hot Water And Cold Water; Adjusting The Standard Water Dispensing Volume - Siemens pureFlow DW03500 Serie Instrucciones De Empleo

To interrupt the dispensing of water
Press the dispensing
■
To dispense water for 1 minute (60 seconds)
Press and hold the dispensing button
■
3 seconds to start.
Info
While the water runs, the glass light will remain lit
and the status light bar of the chosen selection but-
ton blinks. Both blink rapidly immediately before
dispensing stops.
LED indicators for hot water and
cold water
The two lowest LED indicators (red for hot water
and blue for cold water) light up when the respec-
tive cooling and heating functions are operating.
The other LEDs (2, 3 and 4) indicate the respective
water temperature. The more LEDs lit, the hotter or
colder the water is.
LED Hot water
Appliance in
operation
75 – 83 °C
167 – 181 °F
83 – 91 °C
181 – 196 °F
91 – 96 °C
196 – 205 °F
button again.
for
LED Cold water
Appliance in
operation
10 – 13 °C
50 – 55 °F
7.3 – 10 °C
45 – 50 °F
5 – 7.3 °C
41 – 45 °F
en
Adjusting the standard water dispensing
volume
The appliance has been adjusted at the factory to
dispense a certain standard water volume: 120 ml.
This setting can be changed. There are three vol-
umes to select from: 120 ml, 200 ml and 300 ml.
LED Hot water
To change the setting, proceed as follows:
Press and hold the selection buttons
■
water) and (Hot water) simultaneously for at
least 3 seconds to switch into SET mode.
One of the hot water LEDs briefly lights up and a
signal tone is emitted.
Now, press the selection button
■
select the volume.
To save the setting, press and hold the selection
■
button (Ambient) for at least three seconds.
All LEDs light up two-times. The setting has been
saved.
Dispensing volume
120 ml
200 ml
300 ml
(Hot water) to
(Cold
35