Child Protection; Saving Energy; Location; Light Sensor - Siemens pureFlow DW03500 Serie Instrucciones De Empleo

Child protection

The user must start dispensing within 4 seconds
after pressing the selection button
Otherwise, for reasons of safety, the appliance
switches automatically into the function "Cold
water".
The appliance is equipped with a child protection
system so that children can not be scalded by hot
water.
If the child protection system is activated, hot water
can not be dispensed.
To activate or deactivate the child protection sys-
tem, proceed as follows:
Press and hold the push-button
■
3 seconds.
The child protection LED (25a) lights up and indi-
cates that this is activated.
To deactivate, press and hold the push-button
■
again for at least 3 seconds.
The child protection LED switches off. Hot water can
be dispensed once again.
36
en

Saving energy

Location

(Hot water).
Selecting the right location is important in terms of
energy consumption.
Erect the appliance in a dry, ventilated room.
■
Do not place in direct sunlight or in the vicinity
■
of a heating source (e.g. radiator, oven).

Light sensor

The light sensor (19) measures the daylight and
automatically reduces energy consumption when it
is dark by decreasing the frequency of heating and
for at least
cooling cycles. This function can be switched on
and off.
LED Cold water
Press and hold the selection buttons
■
water) and
least 3 seconds to switch into SET mode.
One of the hot water LEDs briefly lights up and a
signal tone is emitted.
Now, the light sensor can be switched on and
■
off by pressing the selection button
water).
To save the setting, press and hold the selection
■
button
All LEDs light up two-times. The setting has been
saved.
Light sensor swiched on
(energy-saving)
Light sensor swiched off
(Hot water) simultaneously for at
(Ambient) for at least three seconds.
(Cold
(Cold