Publicidad
Idiomas disponibles
Idiomas disponibles
A BAD USE OR SETTING OF THESE DEVICES MAY CAUSE A MALFUNCTION OR EARLY DEGRADATION OF THE
STOVE.
Thermostat connection.
Power connection ~230/240V - 50Hz.
Thermostat.
5.
CLEANING AND MAINTENANCE.
To ensure the correct operation of your stove, the following Cleaning and maintenance operations are
necessary at the indicated frequency. The stove must always be cold.
The deterioration of the stove parts by a lack of cleaning involves the loss of the two-year warranty offered
by ECOFOREST (see warranty section).
5.1.
Heat Exchanger.
Pull the drawers of the rake-this shall be done while the glass door closed in order to reach the ash inside the
stove. This shall be done every day when the stove is cold.
In Moon (drawing 10) model, a greater weekly cleaning must be made on the heat exchanger (
better access to the exchanger and clean it perfectly, in Moon model you have to push up the top plate of
the fireplace (
), to disengage the tabs which secure it to the center plate and pull it. When finished, put
back the top plate being sure that the tabs are properly seated. In Atenas model, the top plate (
fixed with a plate and a screw (
Moon model.
Top plate of the fireplace.
Heat exchanger.
5.2.
Ash in the fireplace.
When opening the door, you reach the burn pot where combustion takes place; hoover it and remove it
(make sure you'll put it back properly) in order to clean all holes; make sure they're clean and hoover the
support of the burn pot as well.
DAILY CLEANING WHEN THE STOVE IS COLD.
Drawing 9
)
on each side, which must be removed, and repeat the steps indicated for
33
Drawing 8
). To gain
) is also
Drawing 10
Publicidad
