Notes
• Insert the CF memory card with its
front side towards the NETWORK
indicator.
• For the verified CF memory cards,
contact your authorized Sony dealer.
2 PC card slot
This slot is used for the optional SNCA-
CFW1 wireless card or recommended
ATA memory card.
In case of the wireless card: Insert the
SNCA-CFW1 into a commercially
available type II-PCMCIA adaptor and
insert the adaptor into the PC card slot.
A wider wireless LAN area is available
if you attach the optional SNCA-AN1
wireless LAN antenna to the SNCA-
CFW1.
Notes
• Insert the PC card with its front side
towards the bottom of the camera.
• For the verified ATA memory cards,
contact your authorized Sony dealer.
3 PC card lever
Press the lever to remove the PC card
from the PC card slot.
4 CF card lever
Press the lever to remove the CF
memory card from the CF card slot.
5 NETWORK indicator (green)
The indicator lights up or flashes in
green when the camera is connected to
the network.
The indicator goes off when the camera
is not connected to the network.
6 Lens
A × 26 optical zoom, auto-focus lens is
mounted as standard equipment.
7 POWER indicator (green)
When the power is supplied to the
camera, the camera starts checking the
system.
If the system works normally, this
indicator lights up.
If a system error occurs, this indicator
flashes every second. In this case,
consult your authorized Sony dealer.
Rear
8 9 0 qa qs
CLASS 2 WIRING
8 DC IN 12 V (power input)
connector
Connect the supplied AC power adaptor.
T
(video output) connector
9
(BNC type)
Outputs a composite video signal.
Connect to a composite video input
connector of a video monitor, etc.
q; LAN (network) port (RJ45)
Connect to the 10BASE-T or 100BASE-
TX network using a network cable
(UTP, category 5).
Location and Functions of Parts and Controls
qd
qf
SEE INSTRUCTION MANUAL
5
m
10 9 8 7 6 5 4 3 2 1
LAN
11
GB