Sony SNC-RZ50N Manual De Instalación página 62

and Default gateway in the relevant
boxes.
Note
When you select Obtain an IP address
automatically, make sure that a DHCP
server is operating on the network.
8
Set the DNS server address.
To obtain the DNS server
addresses automatically:
Select Obtain DNS server address
automatically.
To specify the DNS server
addresses manually:
Select Use the following DNS server
address, and type the Primary DNS
server address and Secondary DNS
server address in the relevant boxes.
Note
The Third DNS server address and
Fourth DNS server address are invalid
for this camera.
9
Set the HTTP port number.
Normally select 80 for the HTTP port
No. To use another port number, select
the text box and type a port number
between 1024 and 65535.
24
GB
Assigning the IP Address to the Camera
10
Type the Administrator name
and Administrator password.
The default settings of both items are
"admin."
Note
You cannot change the Administrator
name and Administrator password in this
step. To change these items, see "Setting
the User – User Menu" of the User's Guide
stored in the supplied CD-ROM.
11
Confirm that all items are
correctly set, then click OK.
If "Setting OK" is displayed, the IP
address is correctly assigned.
12
To access the camera directly,
double-click the camera name in
the list.
Tip
The factory setting of the camera network
is as follows.
IP address: 192.168.0.100
Subnet mask: 255.0.0.0