brennenstuhl SOL SV0805 P1 IP 44 Manual De Instalación Y Operación página 8

Ocultar thumbs Ver también para SOL SV0805 P1 IP 44:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
043413 SOL SH_LH Doppelstrahler 08.03.16 12:13 Seite 8
TIME knob towards the (+) sign to increase the light ON time or
towards the (-) sign to decrease the light ON time.
Please note: The selected cycle will start after the motion
detector has been triggered. The cycle starts over with each
subsequent detection.
/ (LUX) = Sensitivity: The LUX adjustment knob can be used
to adjust the amount of ambient light required for the device to
switch on. This helps to prevent the light from switching on
during daylight hours. In the ( ) position the light switches on
during the day and at night, whereas in the ( ) position it only
comes on at night. The desired ambient light at which the unit
starts operating can be adjusted with the LUX adjustment knob.
REPLACING THE BATTERY
Please note: Before replacing the battery the switch on the
lamp unit must be set to OFF and the solar module must be dis-
connected from the main unit. To replace the battery, open the
cover of the main unit as described in Fig. 1 and 2 in the section
"Main Unit". Remove the old batteries from the holder and
insert new ones If possible, charge the rechargeable batteries
first using a standard charger for 1.2 V AA NiMH batteries.
If unable to charge the batteries with a charger please follow
the instructions in the section "CHARGING THE SOLAR LIGHT
FOR THE FIRST TIME".
Reverse the instructions to re-assemble the device.
Please note: Pay attention to correct polarity when inserting
the batteries. Incorrect polarity may damage the device and
the batteries.
GENERAL SAFETY NOTES
1. Only use the solar module included in the delivery. Using a
different solar module may result in injuries or damage to
the light and may void the warranty.
2. When installing the cable make sure it is fastened securely
and does not pose a hazard (e.g., tripping hazard). Stop
using the solar light if the cable is damaged or defective.
CLEANING
Keep the motion detector free from dust and deposits by
wiping it with a damp cloth from time to time. Do not use
chemicals or abrasives to clean the device. Keep the solar
module free from dirt and deposits. A dirty photovoltaic cell is
unable to fully charge the batteries. This may reduce the life of
the battery and result in an unreliable device.
STORAGE
To avoid damaging the batteries, follow these steps to store
your light inside the house for longer than two or three days:
1. Turn the switch to the OFF position.
2. Store the light and the solar module in a location where they
will be exposed to sunlight or ambient light every day. The
rechargeable batteries require light in order to stay charged
during storage.
3. If storing the unit for an extended period it must be fully
charged every four months. Avoid long storage times to
maintain performance.
MALFUNCTIONS
(FAILURE / CAUSE ➔ REMEDY)
The light doesn't turn on when there is movement within the
monitoring range.
Possible Solutions:
Make sure that:
- The switch is in the ON position.
- The LUX adjustment knob is not turned too far towards ( )
- The motion detector is set at the correct angle for detecting
movement.
- The photovoltaic cell is aligned to receive as much direct
sunlight as possible during the day.
- The battery charge is not too low (charge over 3-4 sunny
days with the switch set to OFF).
The light turns on during the day.
Possible Solutions:
- Make sure the LUX adjustment knob is not turned too far
towards ( ).
More information can be found in the Service/FAQ section on
our homepage, www.brennenstuhl.com.
SPECIFICATIONS:
Batteries:
SOL SV0805 P1 IP44, SOL LV0805 P1 IP44,
SOL SV0805 P2 IP44, SOL LV0805 P2 IP44:
3 x 1.2 V / 2200 mAh Ni-MH rechargeable batteries
SOL SV1205 P2 IP44, SOL LV1205 P2 IP44:
3 x 1.2 V / 2500 mAh Ni-MH rechargeable batteries
Solar Module:
SOL SV0805 P1 IP44, SOL LV0805 P1 IP44:
190 x 115 mm
SOL SV0805 P2 IP44, SOL LV0805 P2 IP44,
SOL SV1205 P2 IP44, SOL LV1205 P2 IP44:
220 x 190 mm
Number of LEDs:
SOL SV0805 P1 IP44, SOL LV0805 P1 IP44,
SOL SV0805 P2 IP44, SOL LV0805 P2 IP44:
8 x 0.5 W
SOL SV1205 P2 IP44, SOL LV1205 P2 IP44:
12 x 0.5 W
adjustable:
from approx. 10 seconds to 1 minute
Sensing angle:
180º horizontal
Range:
max. 10 metres
Sensitivity:
adjustable from daylight to night
Type of protection:
IP44
Ambient temperature: -15 °C - +45 °C
DISPOSAL
Dispose of electrical devices in an environmentally
responsible manner! Do not dispose of electrical
devices with household rubbish.
In accordance with Directive 2012/19/EU on waste electrical
and electronic equipment, used electrical equipment must be
collected separately and reused or recycled in an environmen-
tally responsible manner. Please contact your local authorities
for available disposal options for your worn-out device.
Improper disposal of batteries and rechargeable batteries
damages the environment!
Batteries and rechargeable batteries do not belong in the
household rubbish. They may contain toxic heavy metals and
must be treated as hazardous waste. Please take your used
batteries to a community collection centre.
8

Publicidad

Tabla de contenido
loading

Tabla de contenido