Grundig Globe Traveler G3 El Manual Del Propietario página 9

DELETING THE CONTENTS OF ALL MEMORY PAGES
If you want to delete the contents of all memory pages , you must
RESET the radio. Resetting the radio deletes all memories and resets the
radio to factory defaults. With the radio turned off, press the 'COPY'
'ERASE' 'EDIT' buttons in turn, 'FACTORY' will flash in the LCD and
numbers will count down from 10 to 1, after the count down is finished
release the buttons and press the 'RESET' button, inside the hole
labeled RESET. All memory pages are erased and the factory default
settings are restored.
SETTING YOUR TIME ZONE
1. With the G3 turned on or off, perform a 2 second press of TZ
(time zone) button; the time zone flashes in the display, with the
number of minutes ahead or behind GMT (Greenwich Mean Time).
2. Use the tuning knob or quick, short presses of the TZ button to select
your home time zone (see time zone abbreviation list below).
3. Press PAGE/TIME to confirm the setting.
Time Zone Abbreviation List:
ANC-Anchorage BEG-Beijing
BKK-Bangkok CAI-Cairo
CCS-Caracas CHI-Chicago
DAC-Dhaka DEL- Delhi
DEN-Denver DXB-Dubai
GMT-GMT HKG-Hong Kong
HNL-Honolulu JED-Jeddah
KHI-Kashi LAX-Los Angeles
LON-London NOU-Noumea
NYC-New York City PAR-Paris
RIO-De Janeiro SYD-Sydney
TYO-Tokyo WLG-Wellington
16
GLOBE TRAVELER G3 OWNER'S MANUAL
SETTING THE CLOCK AND WEEKDAY
The G3's clock is in 24-hour format. Turn off the G3.
1. With the G3 turned off, press the PAGE/TIME button for about 2
seconds or until the hour digits start flashing.
2. While it's flashing press F1-7 to highlight today's weekday. F1 is
Sunday F2 is Monday, etc.
3. While it's still flashing (or within 3 seconds) use the tuning knob to
set the correct hour, then immediately press PAGE/TIME again, noting
that the minute digits start flashing.
4. While they're flashing (or within 3 seconds) use the tuning knob to
set the correct minutes.
5. Immediately press PAGE/TIME again. The clock and weekday are set.
SETTING ALARMS 1 THROUGH 4
The G3 has 4, independently programmable alarm timers (buttons
F1-4 when the radio is turned off) to turn it on at a specified time.
Additionally, each timer can be programmed for a specific weekday,
volume, playtime and memory location. We suggest that you read this
procedure thoroughly setting.
To set an alarm:
1. With the G3 turned off, perform a long press of one of the F1-4
buttons (about 3 seconds), causing the hour to flash.
2. While it's still flashing press one of the F1-7 buttons to highlight
the day(s) of the week for the alarm turn on. Notice that a square
surrounds the F1-7 button that you've pressed. Place squares around
all 7 of them if you want the alarm to activate each day.
3. While it's flashing use the tuning knob to set the hour; and Press the
PAGE/TIME button causing the minutes to flash.
4. While they're flashing use the tuning knob to set the minutes, then
press the PAGE/TIME button causing VOL (volume) to appear.
5. While it's in the display use the tuning knob to set the wake-up
volume, then press the PAGE/TIME button, causing the alarm's play
minutes to appear as DELAY.
GLOBE TRAVELER G3 OWNER'S MANUAL
17