Adjusting The Volume - SUOMY D20 Manual De Instrucciones

10. Pairing two helmets
This procedure pairs two SCS kits and activates the intercom function between
them. Communication with the intercom function is possible at a maximum
distance of 200 metres. This distance depends on the environmental and road
conditions.
• Put two helments with the SCS kits close together
• Set the intercom pairing mode on both the helmets: press the ON button
for 4 seconds (emission of a double high-pitched tone)
• Press the ON button (short press)on one of the two helmets
• After a few seconds, a high-pitched tone confirms the pairing and the
intercom mode is automatically activated. A low-pitched tone indicates
that pairing has failed
If, during the intercom mode, the distance is such between the two helmets that
the connection is lost, it will be automatically attempted for the next 2 minutes.
If it cannot be reactivated, it will be closed.
A short press on the ON button is enough to reactivate it.

11. Adjusting the volume

You can adjust the volume by a short press of the button
by a tone in the earpiece).
You can set 6 different levels of volume and each time you press the
button, the volume goes up one step and, vice versa, the
it. A high-pitched tone is the sign that the maximum level of volume has been
reached, whilst a low-pitched tone marks the minimum level.
The next time you switch the helmet on, the last volume setting is automatically
restored.
Caution: the volume should not be at settings that are too high becuase this
can distract attention from driving and reduce the possibility of hearing exter-
nal noises or warning signals from other vehicles.
86
-
+
or (confirmed
-
button lowers
+