Community Mode; Friends' Helmets Mode - SUOMY D20 Manual De Instrucciones

Ocultar thumbs Ver también para D20:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

14.1 Community mode

When this mode is activated, each helmet with the SCS kit is continuously
looking for other similar ones to communicate with them.
Proceed as follows to activate the COMMUNITY mode:
Switch off the SCS kit
Press (LONG) the ON and
four high-pitched confirmation tones.
The function is now active and will remain active until the helmet is switched
off.
When the helmets are detected, you will hear the welcome message and the
communication can be accepted with the ON button.
To refuse it, do not press anything.
14.2 Friend's helmet function
A further evolution of the COMMUNITY function is the FRIEND'S HELMET
function, which makes it easier to find helmets of friends considered priority.
In the box when you purchased the kit, there is a univocal code (Friend Ad-
dress) which identifies it. When you enter this code into the special box of
the configuration software allows recognizing that specific kit (see software
instructions).
This way you can create a list of friends pairing each univocal code with the
name of a friend (see software instructions in the CD provided).
The following can be entered in the configuration software of each FRIEND'S
HELMET:
Name of friend's helmet (compulsory)
Friend Address (compulsory)
Phone number (optional)
Proceed as follows to activate the FRIEND'S HELMET:
Press (LONG) the ON and
high-pitched tones of confirmation.
90
-
buttons simultaneously and you will hear
+
buttons simultaneously, you will hear four

Publicidad

Tabla de contenido
loading

Tabla de contenido