Fig - Craftsman professional 152.217050 Manual De Instrucciones

Fig. 4-2 I
TO AVOmD SERmOUS mNJURY AND DAMAGE TO THE
JOmNTER/PLANEFt:
1, DO NOT assemble the Jointer/Planer until you are
sure the tool mSNOT plugged in,
2, DO NOT assemble the Jointer/Planer until you are
sure the power switch is in the "OFF" position,
3, DO NOT assemble the Jointer/Planer until you have
read and understood this entire instruction Manual,
4, DO NOT assemble Jointer/Planer if any parts are
missing or damaged,
C
13"
A
B
1, Lay the left side panel assembly (A) on a clean sur-
face as shown in Figure 4-1, Note: The left side
panel assembly has the large square cut out (B) in it,
2, Assemble the bottom plate (C) to the left side panel
assembly with four M6 x 12mm hex head screws
(D), M6 fiat washers (E) and M6 hex nuts (F), Do
not completely tighten hardware, Note: The bottom
plate must be assembled to the bottom of the left
side panel assembly, The bottom of the left side
panel is 13-inches from the bottom of the square
cut out as shown in Figure 4-1,
3, Position the stand assembly (G) upright and assem-
ble the right side panel assembly (H) to the bottom
plate (C) using four M6 x 12mm hex head screws,
M6 fiat washers and M6 hex nuts, Do not com-
pletely tighten hardware, Note: Make sure to posi-
tion the power cord hob (I) in the right side panel
assembly to the top, See Figure 4-2,
C
G
4,
Assemble the top plate (J) to the stand assembly
(G) with four 3/8-16 x 1" hex head screws (R), Do
not completely tighten hardware, Note: Make sure
the top plate is positioned with single mounting hob
(K) to the left side panel assembly (A) and the two
mounting hobs (L) to the right side panel assembly
(H) as shown in Figure 4-3,
N
11
5,
Finish securing the left and right side panel assem-
bibs to the top and bottom plates by using four
#10-24 x 3/8" round head flange screws, Call outs
(P) in Figure 4-3 and 4-4 show these locations that
need secured,