Craftsman professional 152.217050 Manual De Instrucciones página 8

UNPACKUNG AND CHECKUNG CONTENTS
The Jointer/Haner is a heavy machine, two peopb are
required to unpack and lift it, This machine will require
some amount of assembly, You will need for assembly
a #2 Phillips screwdriver, 8mm, lOmm, 14mm, 16mm,
17mm and 19mm open end wrench (not included), Hex
wrenches 2,5mm, 3mm, 4mm and 6mm are provided,
1, Remove all parts from the carton and lay them on a
clean work surface,
2, Two or more people are required to lift the
Jointer/Planer out of the carton,
3,
Remove all protective materials and coatings from
the parts, The protective coatings can be removed
by spraying WD-40 on a part and wiping it off with a
soft cloth, This may need to be redone several
times before all of the protective coatings are
removed completely,
4,
5,
CAUTION: DO NOT use acetone, gasoline or
lacquer thinner to remove any protective coatings,
After cleaning, apply a good quality automotive wax
to any unpainted surfaces, Make sure to buff out
the wax before assembly,
Compare the parts to figures 2-1,2°2, and 2-3,
Verify that all items are accounted for before dis-
carding the shipping carton, if there are any missing
parts, call Customer Helpline 1-800-897°7709,
Please have your part number ready, Part numbers
can be found in the Parts List section of your
instruction Manual,
To avoid injury, DO NOT turn on the Jointer/Planer until
all parts have been assembled correctly, if any parts
are broken or missing DO NOT use until the parts have
been obtained and assembled,
Fig. 2-1
2
9
1, Front panel
Note: This panel has the Craftsman Professional
label,
2, Back panel
3, Right side panel assembly
4, Left side panel assembly
Note: The left side panel assembly has the large
square cut out in it,
5, Top plate
3 4
10
11
6, Bottom plate
7, Dust chute
8, Push blocks (2)
9, Dust chute port
Note: Dust Chute Port is only to be assembled if a
dust collector is to be used with this Jointer/Planer,
10, Cutterhead pulley guard
11, Push block holder