Craftsman professional 152.217050 Manual De Instrucciones página 14

BELT ASSEMBLY GUARD AND SWITCH ASSEMBLY
DO NOT assembb the Jointer/Haner until you are sure
the power switch is in the "OFF" position and the power
cord is disconnected from the power source,
Fig. 8-1
A
DO NOT assembb the Jointer/Haner until you are sure
the power switch is in the "OFF" position and the power
cord is disconnected from the power source,
Fig. 9-1
O
D B A
G
2,
8,
4,
8,
6,
Using a straight edge, make sure the cutterhead
pulby (A) and motor pulby (B) are aligned to each
other, See Figure 8-1,
To make adjustments to one or both pulbys, first
loosen the set screws in the pulby, Move the
pulby in or out to make proper alignment,
After proper alignment, tighten set screws,
Hace belt (C) through belt opening (D) in top plate
and place belt over cutterhead pulby and motor
pulby, Note: The motor (E) will need to be moved
up higher on the dust chute (F) to allow belt around
both pulleys, See Figure 8-1,
Tension the belt by moving the motor down the dust
chute, Note: Proper tension is achieved when there
is approximately 1" deflection at the center of the
belt span using light finger pressure,
After achieving proper tension, check again for
proper pulley alignment, Then tighten motor
mounting hardware securely,
1,
2,
8,
Assemble the cutterhead pulley guard (A) to the top
plate (B) with two M6 x 12mm hex head screws, M6
fiat washers and M6 hex nuts and tighten all hard°
ware, See Figure 9-1,
Assemble the ON/OFF switch assembly (C) to the
back side of the infeed table (D) with two M8 x
30mm hex socket head screws, M8 fiat washers
and M8 hex nuts,
Place the special plug end (E) of the ON/OFF
switch assembly through the hob in the side panel
and connect it with the special receptacle end (F) of
the motor assembly, Make sure they are complete-
ly seated together and that they are not contacting
the belt (G),
14