Hilti DX 9–HSN Manual De Instrucciones página 17

Result 2 / 3
The tool can be pressed fully against the working surface (the spring on the pressure pin is fully
compressed) and a click is heard when the trigger is pressed.
The nail detector in the tool is working correctly and the tool can be used.
Result 3 / 3
The tool can be pressed fully against the working surface (the spring on the pressure pin is fully
compressed) but no click is heard when the trigger is pressed.
▶ Have the tool repaired by Hilti Service.
5.1.3 Loading fastener strips
1. Insert 6 fastener strips in the magazine from above.
Materials
Fasteners
X­HSN 24
2. Press the last fastener strip in until it lies flush with the magazine.
5.1.4 Loading cartridge strips
1. Insert the cartridge strips from above in the cartridge loading channel.
Materials
6.8/11 M40 red or other cartridges of a type approved for use with the tool (please refer to the car-
tridge recommendations printed in the instructions for use of the fasteners)
2. Press the cartridge strip into the cartridge loading channel until it lies flush with the top edge of the
cartridge loading channel.
5.1.5 Opening the rotating sleeve
▶ Turn the rotating sleeve as far as it will go. Use the scraper or some other tool as an aid, if necessary.
If the fastening tool is jammed, it will then be possible to access the catch.
5.1.6 Closing the rotating sleeve
▶ Turn the rotating sleeve as far as it will go. Use the scraper or some other tool as an aid, if necessary.
If the rotating sleeve is not fully closed it will not be possible to press the fastening tool fully against
the working surface and, accordingly, the tool cannot be operated.
5.2 Operation
5.2.1 Driving fasteners
CAUTION
Risk of injury! If the tool is extremely hot (see service indicator display) cartridges may explode due to the
effect of the heat, causing flying fragments.
▶ Remove the cartridges from the tool immediately before breaks between working.
▶ If the cartridges cannot be removed from the tool, lay the tool down and make sure that all persons keep
a safe distance away from the tool (3 meters) until the pointer on the temperature indicator has moved all
the way to the left. Notify Hilti Service immediately.
1. Press the tool fully against the working surface at right angles.
2. Press the trigger buttons on the grip.
If the tool does not fire, check that a cartridge strip has been loaded and that there are enough
fasteners in the magazine.
The fasteners are not transported when the magazine contains less than 15 fasteners. You must
first insert additional nail strips in the magazine.
*2194029*
2
3
4
5
6
2194029 English 9