Hilti DX 9–HSN Manual De Instrucciones página 23

Trouble or fault
The cartridges are not trans-
ported.
The cartridge strip cannot be
removed.
The tool doesn't fire.
Nail stand-off is too low.
Nail stand-off is too high.
Shear breakage.
*2194029*
Possible cause
The cartridge strip is damaged.
The tool is damaged.
The tool is damaged.
Misfire
The cartridge strip is used up.
There are less than 15 fasteners in
the tool.
The tool is not adequately com-
pressed.
Fastener transport malfunction.
The tool is clogged with dirt.
The cartridges are unsuitable.
The tool is damaged.
The fastener missed the beam.
Driving power is too high.
The piston and piston brake are
worn and/or damaged.
The piston brake wasn't fitted.
The fastener is too close to the
edge of the beam.
Driving power is too low.
The tool is clogged with dirt.
The piston is broken.
The tool is damaged.
The fastener was driven into the rib
of the beam.
The fasteners are not suitable for
the supporting material.
2194029
Action to be taken
▶ Change the cartridge strip. Do
not attempt to forcibly remove
cartridges or the cartridge strip.
▶ Contact Hilti Service.
▶ Contact Hilti Service.
▶ Remedy the malfunction.
→ page 14
▶ Remove the cartridge strip from
the tool.
▶ Insert a new cartridge strip.
▶ Load new fastener strips.
▶ Press the nose of the tool
against the working surface
again and pull the trigger.
▶ Check that the fastener strips
are free to move.
▶ Remove any damaged or
defective cartridge strips or
strips containing damaged or
defective fasteners.
▶ Clean the tool.
▶ Contact Hilti Service.
▶ Do not attempt to forcibly
remove cartridges or the
cartridge strip.
▶ Contact Hilti Service.
▶ Mark the position of the beam
and drive another fastener.
▶ Reduce the driving power
(adjust the power regulation) or
use less powerful cartridges – if
available.
▶ Change the piston and piston
brake together (as a set).
▶ Fit the piston brake into the
base plate.
▶ Mark the position of the beam
and drive another fastener.
▶ Increase the driving power
(adjust the power regulation) or
use more powerful cartridges –
if available.
▶ Clean the tool.
▶ Change the piston and piston
brake together (as a set).
▶ Contact Hilti Service.
▶ Mark the position of the rib of
the beam and then drive another
fastener alongside.
▶ Use only the fasteners specified
for the material for which they
are intended, in accordance
with the instructions.
English 15