Check Oil Level; Installation; Hoses And Connections; Methods To Prevent Freezing - Chicago Pneumatic CP 0044 Instrucciones De Seguridad Y De Funcionamiento

CP 0044
Warning label
Warning - Be sure that the flange drive lugs are
engaged with the motor nut before operating the
saw.
Rotation label
Check oil level label

CHECK OIL LEVEL

Installation

Hoses and connections

A
B
Compressed air source
A.
B. Water separator (optional)
C. Max. 10 feet (3 meter) compressed air hose
between the water separator and the machine.
9800 0543 90 | Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
C
Safety and operating instructions
♦ Check that you are using the correct
recommended operating pressure, 87 psi (6 bar
(e)).
The maximum permissible air pressure, 90 psi
♦
(6.2 bar (e)), must not be exceeded.
Blow any impurities out of the compressed air
♦
hose before connecting it to the machine.
Select the correct dimension and length for the
♦
compressed air hose. For hose lengths up to 100
feet (30 meters), a hose with a minimum internal
diameter of 3 ⁄ in. (19 mm) should be used. If the
4
hose length is between 100 and 330 feet (30 and
100 meters), a hose with a minimum internal
diameter of 1 in. (25 mm) should be used.

Methods to prevent freezing

Ice formation in the machine can occur when the
ambient air temperature is 32-50 °F (0-10 °C) and
the relative humidity is high.
The following actions can be taken to counteract
the risk of ice formation:
Use CP Airolene Plus Tool Oil as a lubricant. CP
♦
Airolene Plus Tool Oil counteracts freezing.
Use a water separator.
♦
Connecting a water
separator
The length of the air hose between the compressor
and the water separator must be such that the water
vapour is cooled and condenses in the hose before
reaching the water separator.
If the ambient temperature is below 32 °F (0 °C) the
hose must be short enough to prevent the water
from freezing before reaching the water separator.

Lubrication

For problem-free operation, continuous lubrication
of the air motor is required. Before using and after
each eight hours service, remove oil plug and fill
reservoir with recommended oil, see below.
Use a synthetic lubricant such as CP Airolene Plus
Tool Oil or mineral oil with the properties
recommended in the table below.
13