Chicago Pneumatic CP 0044 Instrucciones De Seguridad Y De Funcionamiento página 15

CP 0044
Fitting and removing the blade
Whenever fitting or removing the blade the following
instructions must be observed:
To prevent an accidental start: switch off the air
♦
supply and bleed the machine by pressing the
start and stop device. Disconnect the machine
from the power source.
WARNING Cutting blade can come
loose
The machine can kick back towards the operator
very suddenly and violently. Furthermore, losing
your balance or slipping may cause injury. The
machine can be damaged if the cutting blade is not
properly assembled before use.
Be sure that the flange drive lugs are engaged
►
with the motor nut.
Fitting
1.
Place the blade on the flange drive arbor and
check that the directional arrow on the blade is
pointing clockwise as you face the shaft.
2.
A
Install the outer flange (A) and locknut (B) which
has a left-hand thread, onto the shaft by hand
until finger tight.
3.
B
C
Hold the shaft with a
tighten the outer flange with locknut (B) using
a spanner.
9800 0543 90 | Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
B
1 ⁄ in. Allen key (C) and
4
Safety and operating instructions
4.
Install the washer (D) and pan head screw (E)
and tighten with a screw driver.
5.
Spin blade by hand to check true alignment prior
to use.
Removing
1.
Unscrew the pan head screw (E), and remove
the washer (D).
2.
C
Unscrew the lock nut (B) using a spanner while
holding the shaft with a
3.
Remove the lock nut (B), outer flange (A) and
the blade.
D
E
D
E
B
1 ⁄ in. Allen key (C).
4
A
B
15