When Taking A Break; Maintenance - Chicago Pneumatic CP 0044 Instrucciones De Seguridad Y De Funcionamiento

CP 0044
♦ Use the concrete saw only for cutting. It is not
designed for prying or shovelling away any object.
Use caution when re-entering a cut.
♦
Adjust the blade guard so that the rear section is
flush with the work piece. Sparks, dust and cut
material are collected up by the guard and led
away from the operator.
Kick back
♦
If the contact with the material is at the front of
the blade the concrete saw will be thrown away
with great force, from the work piece being cut.
♦
Never cut with the upper quadrant of the blade,
it produces very powerful and sudden reactive
forces, which can make the operator loose grip
of the concrete saw.
9800 0543 90 | Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
Safety and operating instructions
Pull away
♦
If contact with the material is at the sides of the
blade, the concrete saw tries to pull away from
the operator.
♦
Pinching occurs when the material being cut
closes on the blade. If this happens the saw will
be thrown up and towards the operator with great
force. To avoid pinching support the work piece
in such a way that the cut remains open during
operation.
If the work piece is not securely fixed when
♦
cutting, the work piece can fly away and hit the
operator. To avoid this, always secure the work
piece before operating the machine.

When taking a break

♦ During all breaks you must place the machine in
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
♦ In the event of a longer break or when leaving the
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.

Maintenance

Regular maintenance is a basic requirement for the
continued safe and efficient use of the machine.
Follow the maintenance instructions carefully.
17