Loading Media - QuickLabel QL-800 Guía De Arranque Rápido

Loading Media

1. Turn the wing nut [1] on the end of the mandrel counterclockwise to loosen the mandrel.
2. Loosen the fastener on the outer flange [4]. Then remove the outer flange from the
mandrel.
3. Orient the media roll [2] as illustrated and put it on the mandrel. Make sure the roll makes
contact with the inner flange [3].
4. Turn the wing nut [1] on the end of the mandrel clockwise until you feel resistance. This
secures the roll in place.
5. Put the outer flange [4] on the mandrel. Make sure the outer flange makes contact with the
roll [2].
6. Tighten the fastener on the outer flange [4] until you feel resistance. This secures the outer
flange in place.
7. On the front of the printer, slide the media exit guide [5] all the way to the right toward the
control panel. You can adjust this guide before printing.
8. Place the media near the entry slot and slide the adjustable media guide [6] to the width of
the media. The edges of the media should lightly contact the edges of the fixed media
guide [7] and the adjustable media guide [6].
9. Slowly guide the media into the printer as illustrated. You will feel slight resistance as the
media enters the roller area. Make sure there is no excessive slack in the media during this
process.
10 QL-800 Quick Start Guide