Functioning Control; Checking The Functioning Of External Devices - Aprimatic T3EC Instrucciones Para La Instalación

JP1-2 (OUTPUT FUNCTIONING LOGIC) - The functioning modes of the
output channels 3 and 4 can be selected using the jumpers JP1 and JP2, following
the scheme indicated below. The output channels 1 and 2 operate, in any case, with a
pulse output which has a duration of 1 second.
The receiver microprocessor reads the position of the jumpers JP1-4 at start-up: if there
has been a variation in the confi guration of the jumpers JP1-4, to implement these
changes, you must turn the receiver OFF and back ON again.
Pulse functioning. JP1 and JP2 open: for
button enabling
1 s
every transmitter command given, the output is
output
enabled for a second.
Step functioning. JP1 closed: for every
button enabling
transmitter command given, the output changes
output
state (ON OFF e OFF
Continuous functioning. JP2 closed: the output
button enabling
remains active as long as the transmitter
output
command persists.
CONFIGURATION NOT USED AS IT
DISABLES THE OUTPUT CHANNELS 3 AND 4.
ON).

4. FUNCTIONING CONTROL

After selecting the functioning mode and times, check the external devices connected
to the card.

4.1 CHECKING THE FUNCTIONING OF EXTERNAL DEVICES

Start input- N.O. type contact which supplies the start pulse to the automation.
Stop input - N.C. safety contact which has priority in all states and functions. If the
stop input is given, the device blocks the automation immediately and it only starts
up again when the start push-button is pressed: this closes the automation. When the
stop input is given, the device ignores all the commands.
Photocell input - N.C. safety contact which is only enabled during closing. If the
photocell is obscured, the automation stops for 1 second and then re-opens until the
work time expires. When the automation is open and the photocells are obscured,
the photocells block closing.
Opening safety photocell/closing command input - The function of this
input (terminal n. 12) depends on the setting of DIP-SWITCH 3. The following is a
list of the possible functions:
Opening safety device input – A safety device input which is enabled during
opening or closing. When the input is enabled, the automation stops immediately.
When the input is disabled, it continues to move in the same direction as before. This
function can be used to protect the areas where crushing may occur.
Closing command input – Input which is only enabled when the Dead Man
and Semiautomatic OPEN/CLOSE modes are selected. It closes the automation
when the close push-button is pressed and held down.
Warning light output - 24VDC output with maximum load of 3W, which commands
the automation state warning light. Light OFF: automation closed. Steady light:
automation open or opening. Flashing light: automation closing.
Flashing light output - 24 V output which commands the fl ashing light. This
output commands the fl ashing light with a pulsating power supply with frequency of
1 Hz: the light is ON for 0.5 seconds and OFF for 0.5 sec. If pre-fl ashing is enabled,
this output is enabled 3 seconds before the command to move the automation
(opening and closing).
NOTE - Only use Aprimatic ET Series LED fl ashing lights to avoid a fault with the
output which will cause incorrect functioning of the entire system.