Replacing Ez-Filters - Atmospheric Water Solutions AquaBoy Pro II Manual Del Usuario

10. REPLACING EZ-FILTERS

Pro II makes "purified great tasting water
®
The AquaBoy
replacement schedule. The front display has a set of numbers (1-7). These numbers notify
EZ-Filter ™
you when it is time to replace a filter and which one to replace. Below is the recommended timing for
replacing filters.
HEPA Air EZ-Filter
1
Bottom Tank UV Lamp EZ-Filter
2
Sediment EZ-Filter
3
Pre-Carbon EZ-Filter
4
Ultra-Fine Membrane EZ-Filter
5
Post-Carbon EZ-Filter
6
Top Tank UV Lamp EZ-Filter
7
Resetting the flashing filter light
To reset a flashing filter light: Hold the control panel light button for 3 seconds, then use either the hot
or cold water dispense button to select the appropriate flashing filter light. Once you have the correct
flashing filter light selected, press the hot water lock button.
1. HEPA Air EZ-Filter
a. Unplug the appliance from the wall outlet (picture 2.1-1).
b. Using a Phillips screwdriver, remove both screws from the filter bracket (picture 2.1-2).
c. Remove used HEPA Air EZ-Filter
a new HEPA Air EZ-Filter
towards the inside of the appliance before screwing the filter bracket back in place.
d. Reset flashing filter light (see "Resetting the flashing filter light," page 9).
2.1-1
Unplug from
wall outlet
™
...................................................................................
™ .............................................................
™
..................................................................................
™
...............................................................................
™ ...............................................................
™
.............................................................................
™
...................................................................
™ Replacement
™
™
. Be sure the white tag on the HEPA Air EZ-Filter
2.1-2
Remove these two
screws
www.AtmosphericWaterSolutions.com
™
" from the air by following the recommended
™
from the filter bracket (picture 2.1-3) and replace it with
2.1-3
(Every 3 months)
(Every 12 months)
(Every 6 months)
(Every 6 months)
(Every 12 months)
(Every 12 months)
(Every 12 months)
™
is facing
Take out the
HEPA air filter
Remove the
filter bracket
9