Atmospheric Water Solutions AquaBoy Pro II Manual Del Usuario página 13

4. Bottom Tank UV Lamp Replacement
a. Unplug the appliance from the wall outlet (picture 2.4-1).
b. Using a Phillips screwdriver, remove both screws from the back bottom plate (picture 2.4-2).
c. Carefully grab bottom tank handle and slowly pull out towards you; without interfering with
tubes and wires, empty remaining water from bottom tank (picture 2.4-3).
d. Using a Phillips screwdriver, remove the four screws from the UV lamp cover
(picture 2.4-4).
e. Remove the UV lamp cover, lift the used UV lamp out from the tank receptacle, then
disconnect from the pigtail socket by carefully pulling apart (picture 2.4-4).
f. Connect the new UV lamp with the pigtail socket by slowly pushing the four metal pins
into the top of the lamp.
g. Place the UV lamp back into the tank receptacle and screw UV lamp cover back into place.
h. Carefully replace the bottom tank and back bottom plate.
i. Reset flashing filter light (see "Resetting the flashing filter light," page 9).
2.4-1
2.4-3
Unplug from
wall outlet
Pull out the bottom
tank by tank handle
Remove bottom
back plate
www.AtmosphericWaterSolutions.com
2.4-2
Remove the
two screws
in the bottom
back plate
2.4-4
Remove the screw
and cover
Take out UV lamp
12