Atmospheric Water Solutions AquaBoy Pro II Manual Del Usuario página 11

2. Water Filter Replacement (Replacing Filters 3-6)
a. Unplug the appliance from the wall outlet (picture 2.2-1).
b. Grip the lower face plate firmly on both sides, push down slightly while pulling outward from
the top to remove (picture 2.2-2, picture 2.2-3).
c. To remove filters #4-6, rotate clockwise (as per arrows on filters) and pull down
(picture 2.2-4).
d. Install the new filter by pushing upwards and rotating counterclockwise.
e. To remove filter #3, rotate counterclockwise and pull upward.
f. Install the new filter by pushing down and rotating clockwise.
g. Replace lower face plate.
h. Reset flashing filter light (see "Resetting the flashing filter light," page 9).
Note: It is recommended to replace filters one-by-one.
2.2-1
Unplug from
wall outlet
2.2-4
4 5 6
3
2.2-2
Rotate
clockwise and
Pre-Carbon
pull down to
remove filter
www.AtmosphericWaterSolutions.com
2.2-3
Grip the bottom
front plate firmly
on both sides,
push down
slightly
2.2-5
4 5 6
3
Sediment
Pull bottom
front plate
outward from
the top
Ultra-Fine Membrane
Post-Carbon
10