Glomex DISCOVERY S460S Manual De Instrucciones página 51

7. Select the zone (on the vehicle roof) where to
install the fairlead.
Before drilling the hole, make sure not to dam-
age possible pipes or cables.
Drill a hole by means of an electric drill and a
hollow mill with a diameter of 25 mm on the
vehicle roof for the passage of the 5 m coaxial
cable; use a fairlead code T140.
Apply some sealant like SIKAFLEX®252 or
similar (check that any alternative product has
the same characteristics) around the hole (Fig.
10).
In case 2 cables are installed, by means of a
knife or a blade, remove a plastic tongue from
the fairlead, as indicated in Fig. 11.
Then apply the sealant as previously described.
S
WARNING
Fastening with sealant is necessary and sufficient
for the correct use of the equipment.
Fastening with the screws (not included) of the
radome on the roof is optional.
Fastening with screws only does not guarantee
a perfect coupling of the radome to the roof.
GLOMEX declines any liability for an incorrect cou-
pling of the radome to the vehicle roof.
www.glomexmobile.com
Fig. 10
Fig. 11
49
DISCOVERY S460S
EXPLORER S460M