Glomex DISCOVERY S460S Manual De Instrucciones página 53

Fig. 15
3. Connect the coaxial cable of the antenna (previ-
ously installed) to the ANTENNA IN input on the
control unit and the 1.5 m coaxial cable to the
RECEIVER OUT output on the control unit.
Make sure that the cable cores are correctly
inserted in the central holes of the relevant female
connectors on the control unit (otherwise, there
would be a short circuit and the fuse installed on
the power supply line inside the control unit would
trip, see page 66 for fuse replacement).
Manually screw in the ring nuts of connectors F.
Once the ring nuts have been manually screwed
in, tighten by ¼ turn by means of a 11 mm
wrench.
S
WARNING
The inversion of the two cables jeopardizes the
operation of the equipment. Make sure you have
correctly installed the coaxial cables. In case of
damage, GLOMEX will not be directly liable for the
damage suffered by the receiver.
www.glomexmobile.com
The antenna is designed to operate with a single
decoder; therefore, do not install signal splitters
upstream or downstream the control unit.
Power supply
cable
Red
Black
From the antenna
Fig. 16
4a. Only for Discovery S460S (Fig. 16)
Connect the power supply cable of the control
unit directly to the battery: connect the positive
terminal of the vehicle battery to the red cable
and the negative terminal to the black cable.
The power supply line coming from the battery
GL00095
must have cables with a minimum cross sec-
tion of 2.5 mm
4 mm for longer cables.
2
NOTE: With 5 m cable, MINIMUM power supply:
11.5 V; with 10 m cable, MINIMUM power supply:
12.5 V.
51
DISCOVERY S460S
EXPLORER S460M
S
WARNING
To the receiver
with a length up to 4 m, of
2