Safety Warnings; Personal Protective Equipment - DeVilbiss HGB-509 Manual De Instrucciones

Important: Read and follow all instructions recommendations and safety precautions before using this equipment.
FIRE AND EXPLOSION
Solvents and coating materials can be highly flammable or
combustible, especially when sprayed .
• Work stations must be provided with adequate
ventilation/ exhaust to prevent the build-up of
flammable.
• Smoking and naked flames must not be allowed in
the spraying mixing areas.
• Fire extinguishing equipment must be provided in
the spraying and mixing areas.
Users must be comply with all local and national codes of
practice and insurance company requirements governing
ventilation, fire precautions, operation, maintenance and
housekeeping of work station..
HALOGENATED HYDROCARBON SOLVENTS : for example
1.1.1 Trichloroethane Chloride can chemically react with
aluminum and galvanized or zinc coated parts and cause
an explosion hazard. Read the label and data sheet for the
material you intend to spray.
D O NO T U SE SPRAY MATERIAL CONTAINING
T HE SE SO LVE N TS EXCEPT W ITH EQUIPM ENT
SPECIALLY DESIGNATED BY THE MANUFACTURER
A S B E IN G SU I TA BLE FOR SUCH USE.
STATIC ELECTRICITY is generated by fluid moving through
pipes and hoses. A static spark, capable of igniting certain
solvents and coating materials could be produced by high
fluid flow rates. To prevent the risk of fire or explosion,
earth continuity to all equipment should be maintained.
The fluid back regulator HGB-510 or 509 have stainless
steel body and fluid connectors. Check earth continuity
with ohmmeter equipment, a resistance below 10
recommended.

PERSONAL PROTECTIVE EQUIPMENT

Toxic vapors when sprayed certain materials may
poisonous, create irritation or otherwise be harmful
to health. Always read carefully all labels and safety
performance data for the material being sprayed and
follow any recommendations. IF IN DOUBT CONSULT THE
MATERIAL SUPPLIER.
The use of respiratory
recommended at all times when sprayed.
The type of respiratory protective equipment used must
be compatible with the material being sprayed and level
of concentration.

SAFETY WARNINGS

ohm is
6
protective equipment is
2 / 7
• Always wear eye protection when spraying or
cleaning the equipment.
• Gloves must be worn for spraying or cleaning the
equipment when certain coating materials and
solvents are used.
TRAINING
Personnel should be given adequate training in the safe
use and maintenance of this equipment. Training courses
on all aspects of the equipment are available. For details
contacts your local representative. The instructions and
safety precautions contained in this literature supplied
with the coating material should be read and understood
before the equipment is used.
MISUSE
• Never exceed the recommended safe working
pressures for any equipment used.
• The fitting of non recommended or non original
accessories or spare parts may create hazardous
condition
• Before dismantling the equipment for cleaning or
maintenance all pressures air and material, may be
isolated and released.
The disposal of non metallic materials must be carried
out in an approved manner. Burning may generate
toxic fumes. The removal of waste solvents and coating
materials should be carried out by an authorized local
waste disposal service.
The fluid section materials used in the construction of this
equipment are solvent resistant.
However, the regulator and or the manometer must not be
left inside gun washing machine on plunged inside solvent
in order to do not damaged the gasket or membrane.
The solvents used in the gun washing machine should
be regularly checked to ensure that the equipment is not
flushed through with contaminated material. Follow the
recommendations of the machine manufacturer.
SB-6-HGB-R (11/2015)