General Electric PBM21 Instructivo Y Advertencias página 63

REMOVE THE REFRIGERATOR DOOR
1
Unplug the wire conector and remove the wire out of the
1.11
way until you can see the screws holding the hinge.
Using a 5/16" Socket ratcher/driver, remove the screws
1.12
securing the top hinge to the cabinet.
Lift the hinge straight up to free the hinge pin from the
socket in the top of the door and pass the wire through the
slot hinge.
Installation Instructions
1.13
90 degrees and tilt the door away from the cabinet. Lift the
door off the center hinge pin.
NOTE: For Ice & Water models, the top hinge remains with
the door.
1.14 Set the door on a non-scratching surface with the inside up.
REMOVE CENTER HINGE
2
Using a ¼" hex-key wrench remove the 2 hinge pins from
2.1
the hinge brackets.
REMOVE CENTER HINGE BRACKET
3
Using a 5/16" socket ratcher/driver, remove the screws
3.1
securing from the center hinges to the cabinet.
63