General Electric PBM21 Instructivo Y Advertencias página 67

2 REMOVE THE FREEZER DOOR
(For models with freezer door)
2.2 Tape the door shut with adhesive tape.
2.3 Using a 1/4" Allen screwdriver
remove the hinge pin from the hinge
bracket, the hinge pin will be used
again on the opposite side.
2.4 Remove the tape and tilt the door away from the cabinet.
Lift the door off the bottom hinge pin.
2.5 Using a thin-blade screwdriver remove the button plug from
the left side of the door and install it on the opposite side.
2.6 Set the door on a non-scratching surface with the inside up.
3 TRANSFER CENTER HINGE BRACKET
3.1 Using a 5/16" socket ratcher/driver, remove the bolts securing
the center hinge to the cabinet.
3.2 Locate the plugs button in the kit and install them in the
opposite side of center hinge.
3 TRANSFER CENTER HINGE BRACKET
3.3
Flip the center hinge like the picture
and remount them on the opposite
side, reinstall the screws to 60 in-lbs.
4 INSTALL CENTER HINGE PIN
(For models without freezer door)
4.1 Using Allen screwdriver, install
the hinge pin into the bracket
hinge.
5 REMOVE BOTTOM HINGE
(For models with freezer door)
5.1 Using 5/16" socket ratcher/driver, remove the screws from
the bottom hinge bracket. These will be reinstalled on the
other side.
5.2 Using a Torx T-20 screwdriver remove the screw from
the cabinet and remount it on the opposite side.
67
(cont.)