Important - GE Appliances GFDS175 Manual De Instrucciones

REMOVE THE DOOR ASSEMBLY
1
A. Open the door to approximately 130 degrees.
B. Remove the 6 tapping screws located around
the perimeter of the door outlining the gasket.
Remove the outer ring.
C. Remove 3 hinge screws starting at the bottom
and move up. Make sure the door is supported
while removing the screws.
D. Loosen the top screw as shown. Unhook the door
by lifting and pulling. Remove the top screw.
Installation Instructions
Then loosen top
screw, remove door
and remove screw
First remove
three lower
hinge screws
11
2 REMOVE HINGE AND COVER
IMPORTANT: Note the location of the hinge (left or
right) before removing.
A. Remove the 6 machine screws from the hinge
and the 2 machine screws from the hinge cover.
Hinge
B. With the screws removed, turn the door over and
separate the outer door assembly and hinge cover
of the door from the door frame and set aside.
Hinge
REINSTALL HINGE ASSEMBLY
3
A. Place the hinge in the opposite side of the door
as shown. Push the hinge in place until the hinge
holes align with the door holes.
Hinge
Cover
Hinge
Cover
Hinge shown
on opposite
side