GE Appliances GFDS175 Manual De Instrucciones página 18

Before you call for service...
PROBLEM
Time Remaining
jumped to a
lower number
Cannot make a
selection and the
dryer beeps twice
Dryer is running but
END is displayed in
Time Remaining
Clean Lint Filter (message) Power button was activated
Dryer doesn't heat
Inconsistent drying times
Clothes are still wet
and dryer shut off
after a short time
Clothes are wrinkled
18
Possible Causes
The estimated time may change
when a smaller load than usual
is drying
or option that you are
trying to select is incompatible
with the chosen dry cycle
The Ext Tumble/Wrinkle Care
option was chosen
Fuse is blown/circuit breaker
but not heat
Gas service is off (gas models
only)
LP gas supply tank is empty
or there has been a utility
interruption of natural gas
(gas models only)
Type of heat
Type of load and
drying conditions
The door was opened mid-cycle.
The load was then removed from
the dryer and a new load put in
without selecting a new cycle
Small load
Load was already dry except
for collars and waistbands
Dryer is not level
Overdrying
Letting items sit in dryer after
cycle ends
Overloading
What To Do
remaining is not displayed. The extended tumbling
option lasts approximately 60 minutes.
Start/Pause to begin a dry cycle and the message
will disappear.
replace both fuses or reset both breakers. Your dryer
may tumble if only one fuse is blown or one breaker
tripped.
fully open.
service is restored.
If you recently changed from an electric to a gas
(natural or LP) dryer, or vice versa, the drying time
could be different.
length and condition of the exhaust system will affect
drying times.
is put in.
Time Dry.
Quick Dry or Time Dry to dry damp collars
and waistbands. In the future, when drying a load with
collars and waistbands, choose More Dry.
as necessary until even.
moisture. Select a Less Dry or Damp setting.
immediately, or use the Ext Tumble/Wrinkle Care option.
Quick Dry or