Publicidad
The instrument contains static sensitive devices, and care must be taken in
handling the printed circuit board. If an instrument's protection has been
impaired it should not be used, but sent for repair by suitably trained and
qualified personnel. The protection is likely to be impaired if for example; it
shows visible damage; fails to perform the intended measurements; has been
subjected to prolonged storage under unfavourable conditions, or has been
subjected to severe transport stresses.
NEW INSTRUMENTS ARE GUARANTEED FOR 3 YEARS
Note: Any unauthorized prior repair or adjustment will automatically invalidate
the Warranty.
INSTRUMENT REPAIR AND SPARE PARTS
For service requirements for Megger Instruments contact :-
Megger Limited
Archcliffe Road
Dover
Kent, CT17 9EN
England
Tel: +44 (0) 1304 502243
Fax: +44 (0) 1304 207342
or an approved repair company.
Approved Repair Companies.
A number of independent instrument repair companies have been authorised
for repair work on most Megger Instruments, using genuine Megger spare
parts. Consult the Appointed Distributor / Agent regarding spare parts, repair
facilities, and advice on the best course of action to take.
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it should be sent
freight pre-paid to the appropriate address. A copy of the invoice and of the
packing note should be sent simultaneously by airmail to expedite clearance
through Customs. A repair estimate showing freight return and other charges
will be submitted to the sender, if required, before work on the instrument
commences.
Users of this equipment and or their employers are reminded that
Health and Safety Legislation require them to carry out valid risk
assessments of all electrical work so as to identify potential sources of
electrical danger and risk of electrical injury such as from inadvertent
short circuits. Where the assessments show that the risk is significant
then the use of fused test leads constructed in accordance with the
HSE guidance note GS38 'Electrical Test Equipment for use by
Electricians' should be used.
REPAIR AND WARRANTY
FROM THE DATE OF PURCHASE BY THE USER.
or
Megger Inc.
Valley Forge Corporate Center
2621 Van Buren Avenue
Norristown, PA 19403
U.S.A.
Tel: +1 (610) 676-8579
Fax: +1 (610) 676-8625
Note
Publicidad
