Bevel Stop - Craftsman 5411.3 Manual Del Operador

TO ADJUST
BEVEL SETTING (Fig. 10)
1. Remove the battery pack from
the circular saw when adjusting
the bevel setting.
2. Loosen the bevel-adjustment
knob by turning
it counterclockwise.
3. Raise the motor housing end of
the saw until the indicator aligns
with the desired angle setting on
the bevel scale.
Fig. 10
Indicato ..,
Bevel-Adjustment /
Knob
Bevel Scale
4. Securely tighten the bevel-adjustment knob.
,_k WARNING: Attempting a bevel cut without having the bevel-adjustment
knob securely tightened can result in serious injury.
0 ° BEVEL STOP
The saw has a 0 ° bevel stop that has been adjusted before shipment to ensure
that the blade is vertical to the base at 0 ° bevel cutting.
TO CHECK 0 ° BEVEL
STOP (Fig. 11}
1. Remove the battery pack from
the circular saw when checking
O° bevel stop.
2. Using a carpenter's square
(available separately), check that
the saw blade is square (at a 90 °
angle) to the base of the saw.
TO ADJUST 0 ° BEVEL
STOP (Fig, 12)
1. Remove the battery pack from
the circular saw when adjusting
the 0° bevel stop.
2. Loosen the bevel-adjustment knob.
3. Place the saw in an
upside-down position on
a workbench.
4.
Using a Philips screwdriver
(available separately), turn the
0 ° bevel-stop adjusting screw
until the base is square with
the saw blade.
Fig. 11
Carpenter's square
Fig. 12
19
0 ° Bevel-Stop Adjusting
Screw