Assembly - Evolution DWP1000 Manual Del Proprietário

Fig 1a
(LH view of 3 locating pins)
Fig 1b
(RH view of 3 locating pins)
Fig 1c
(showing 2 rear stabiliser pins)

ASSEMBLY

1. Connecting the DWP100
Water Pump to the Evo-System Engine
Note: Your Evolution Pump is designed to be connected
to and powered by the Evo-System Engine. Do not try to
connect this machine to any other power source. Your Evo-
System Engine has a unique patented coupling that enables
a variety of Evo-System accessories to be connected to and
be driven by this machine.
This coupling is engineered to very fine tolerances and must
be kept clean and free from dirt, debris etc.
A cover for coupling protection is provided with each
accessory and should be used whenever the accessory is
'remote' from the engine.
If you experience difficulty in accessory connection, it could be
because the accessory location pins, or the annuli of either the
accessory or the engine are contaminated or damaged.
Preparing the Engine for accessory connection:
Note: The Evo-System Engine has a micro switch
incorporated within the coupling design that senses
when an accessory has been successfully attached to the
machine. The engine will not start without an accessory
being successfully connected. It cannot be run as a 'stand
alone' machine.
• Lock the Transportation Wheels using the wheelbrake.
• Release the Accessory Mounting Frame by rotating the
locking levers to their unlocked (down) position and push
levers in.
• Deploy the Accessory Mounting Frame.
• Lock the frame into position by pulling out and returning
the locking levers to their locked (upright) position.
Pump connection
Note: The Pump is equipped with 3 locating pins and 2
rear stabilising pins. The 3 locating pins lock into the 'Uni-
coupling'. The other 2 stabilising pins slide into the sockets
in the Accessory Mounting Frame.
• Hold the accessory by its external frame and offer it up to the
engine. Visually align the 3 locating pins (Fig.1a & Fig.1b)
and 2 rear stabilising pins (Fig.1c). Enlist competent help
if necessary.
• Holding onto a convenient part of the external engine
frame can aid the operator achieving and maintaining
alignment when connecting an accessory.
• Gently push the accessory into the engine. Keep the
3 locating pins and the 2 stabilising pins aligned with
their respective docking positions. The internal coupling
between the engine and the accessory will be made
www.evolutionbuild.com
CZ
®
DA
DE
EL
ES
FI
FR
GB
IT
NL
NO
PL
PT
RU
SK
SV
125