Maintenance; Long Term Storage; Environmental Protection - Evolution DWP1000 Manual Del Proprietário

Fig 7
(arrows show inner wall of
annular ring)
Fig 8
(3 locating pins & 2
stabilishing pins highlighted)

MAINTENANCE

Note: The maintenance schedule for the Evolution Evo-System
Engine can be found in the dedicated Instruction Manual.
• Keep the pump clean and regularly check the tightness of
all bolts and fastenings.
• Keep the annular ring scrupulously clean and free
from debris. (Fig. 7)
• Keep the 3 locating pins and 2 stabilising pins clean and
occasionally lightly spray with a silicone oil based spray.
(Fig. 8)
• Keep all Uni-coupling mating surfaces clean and free from
dirt or debris.
• At every connection or disconnection check the accessory
drive cog for dirt or debris contamination, particularly between
the teeth. Clean and lubricate as per the instructions for the
engine drive clutch (found in Engine Instruction Manual).
Do not spray lubricant onto the 'drive cog'.
• If the pump has been used to pump salty or contaminated
water of any kind, it should be thoroughly flushed with
clean water (both the inside and the outside) as soon as
possible after use. The pump body should be drained,
allowed to dry and the drain plug replaced.
• Whenever the accessory is 'remote' from the engine the
coupling protection cover (provided) should be used to
protect the coupling.

LONG TERM STORAGE

We recommend that both hoses (water input and water
output) are removed from the pump. Drain the pump body
of any residual water by removing the drain plug. Store in a
secure, dry location, covered by a clean cloth to prevent the
ingress of dirt, debris etc.

ENVIRONMENTAL PROTECTION

Was electrical or mechanical products should not be
disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for
recycling advice.
www.evolutionbuild.com
CZ
®
DA
DE
EL
ES
FI
FR
GB
IT
NL
NO
PL
PT
RU
SK
SV
129