Bunn SBDA-8 LP Manual De Capacitación Técnica página 244

Dimensions & Specifications
Model Product Dispense Rate
Number
Product Ratios
SBDa-8 LP 43200.xxxx regular: 16:1-60:1
Espresso: 12:1-35:1
SBDa-8 LP 43200.xxxx regular: 16:1-60:1
Espresso: 12:1-35:1
† Ratio based on 1/8" tubing.
*Theoretical Capacity measured with a .355L cup.
Electrical: 120V requires 2-wires plus ground service rated 120V, single phase, 60 Hz.
230V requires 2-wires plus ground service rated 220-240V, single phase, 50/60 Hz.
Plumbing: 20-100 psi (138-689 kPa) from a
a shut-off valve should be installed in the line before the unit. Install a regulator in line when pressure is greater than 100
psi to reduce pressure to 50 psi. Supplied with
14.7"
(37.3cm)
(16.97cm)
CLEARANCE
14.25"
(36.2cm)
Bunn-o-Matic Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • 800-637-8606 • 217-529-6601 • Fax 217-529-6644 • www.bunn.com
®
BUNN practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
®
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
all dimensions shown in inches and centimetres.
Volts
.7 oz.
†
120
230
1 / " or larger supply line. Unit requires a .5 gpm (1.9 litres per minute) line flow capacity.
4
20.3"
(51.6cm)
27.8"
(70.6cm)
6.68"
CUP
Amps Heater Total
Watts Watts
11 1300 1450
8 1850 2000
1 / " male flare fitting.
4
31.3"
(79.5cm)
23.1"
(58.7cm)
ELECTRICAL
OUTLET FOR
WATER PUMP
3.6"
(9.1cm)
Capacity* Cubic Shipping Cord
Measure Weight Attached
12.42L/hr. 5.98 ft 3 83.4lbs.
.169 m 3 37.8kg
17L/hr. 5.98 ft 3 83.4lbs.
.169 m 3 37.8kg
INLET WATER
CONNECTION,
.75 HOSE THD.
2.2" (5.6cm)
9/11 © Bunn-O-Matic Corporation
Yes
No
DRIP TRAY
DRAIN
CONNECTION