Toto ZL Manual De Instalación Y Del Propietario página 7

(4) Install drain assembly (continued)
(a) Insert the drain lift rod into the
guide from below the spout body.
(b) Mount the pushbutton, screw and
lid on the drain lift rod in that order.
(ill. 7)
(c) Fit bushing B, the pivot ball nut and the drain
lift rod connecting part on the pivot arm and fit
bushing A on the drain assembly.
(d) After passing the drain lift rod
through the drain lift rod connecting
part, pass the pivot arm through
the hole of the plunger of the
lever hole and secure it with
the pivot ball nut. (ill. 8)
5. Connect the drain assembly.
(1) Adjust the position of the drain lift rod so
that the clearance between the spout and the
pushbutton is 3/16"- 3/8" (5~10mm).
(2) Lower the pivot arm to the lowest position
in the condition described in part (a), secure
the screw of the drain lift rod connecting part
to anchor the pivot arm and the drain lift rod.
(ill. 9)
CAUTION
If the pivot arm and the drain lift rod interfere with
the wall and the water drain pipe, cut them to a
length that they do not interfere. (ill. 10)
Make sure water is flowing properly after installing
the faucet.
INSTALLATION PROCEDURE
Drain assembly
ill. 7
Guide
Drain lift rod
Pushbutton
Drain lift rod
ill. 8
connecting part
Bushing B
.
Bushing A
Lever hole
ill. 9
Pushbutton
3/16"~ 3/8"
(5~10)
Water drain pipe
ill. 10
7
Connecting pipe
Mixed supply hose
Lid
Screw
Drain lift rod
Drain lift rod
Pivot Ball
Nut
Pivot arm
Wall
Drain lift rod
Pivot arm
*
*
*Cut 3/8"- 13/16"(10~20) from
the anchoring metal fittings.