Warranty; Troubleshooting; Ec Declaration Of Conformity - Dustcontrol 2800 H EX Traduction Des Instructions De Service D'origine

Warranty

The warranty period is two years and covers manufacturing defects. The warranty is valid on condition that the machine is used in
the normal way and receives the required service. Normal wear and tear is not covered. Repairs must be carried out by
Dustcontrol or personnnel authorized by Dustcontrol. Otherwise, the warranty is void.

Troubleshooting

Problem
Motor not running.
Motor stops immediately after starting.
Motor runs, but no suction.
Motor runs, but poor suction.
Machine blows dust.
Abnormal sound from machine.

EC Declaration of Conformity

We hereby declare that DC 1800/DC 2800 H EX is in compliance with the following directives and standards: 2006/42/EC,
2014/35/EU, 2014/30/EU, 2014/34/EU, EN 60204-1, EN 1822-1, DIN EN 60335-1 (11/2010), DIN EN 60335-2-69 (01/2010)
including annex AA and CC. The electrical connector supplied is intended for connection outside the zone. Appropriate electrical
connections must be used in the zone. The machine must not be used for explosive, unstable or self-igniting particles or dust with
a minimum ignition energy of (MIE) < 3 mJ. No hot or glowing particles may be sucked into the machine. The serial number and
year of manufacture are indicated on the rating plate of the machine. The machine must also be labelled as follows:
Dustcontrol AB
Anna-Lena Berg / CEO
2019-11-27
20
Cause
Power supply not connected.
Incorrect fuse.
Suction hose not connected.
Suction hose perforated.
Blocked filter.
Suction hose too long or narrow.
Hose partially blocked.
Top of machine poorly fitted.
Dust trapped in cyclone.
Filter loose or damaged.
Peter Söderling / Technical Manager
1800/2800 H EX, Art.nr. Part 94169-I
Action
Connect power supply.
Replace with correct fuse.
Connect hose.
Replace hose.
Clean or replace.
Replace hose.
Reverse or clean hose.
Adjust fitting.
Remove top and clean cyclone.
Check and replace as necessary.
Book service.