Panasonic AW-RP50E Manual De Usuario página 31

Setting the functions when the unit is linked with the switcher
Bus setting
From the [SETUP] menu, select [SW LINK] and display
[BUS]. Then set the material (AUX, PVW, PinP or KEY) to be
sent to the switcher.
3 . BU S
The materials set using this item are sent from the remote
camera to the switcher when the remote camera has
been selected using one of the unit's CAMERA STATUS/
SELECTION buttons.
Control can also be exercised by assigning this setting to a
USER button (BUSCONT).
Focus assist setting
From the [SETUP] menu, select [SW LINK] and display
[FASIST]. Then set On or Off.
4 . FA SI S T
When "On" is selected as this item's setting, the images of
the AUX bus output from the switcher will be switched to the
images of the remote camera selected by the unit.
Conversely, when "Off" is selected, the switcher will switch
the images of the AUX bus output from the switcher to the
images of its multi view display.
A UX
O ff
30 (E)
Camera information setting
From the [SETUP] menu, select [SW LINK] and display
[CAMSEL]. Then set On or Off.
5 .C AM SEL
When "On" is selected as the item setting, an icon appears
at the bottom left of the image of the remote camera
selected by the unit on the switcher's multi view display.
When a remote camera has been selected, its information is
sent from the unit to the switcher.
Of f