Black and Decker DVJ215J Manual Del Usario página 7

Using the pull out crevice tool (Fig. B,C)
Extend the crevice tool (4) as shown in igure C, until it
u
clicks in place.
To retract the crevice tool (4) press the crevice tool release
u
button (4a) allowing it to return to its normal position
(Fig. B).
Note:
The flip down brush (8) can only be utilised when the
crevice tool is in the retracted position.
Charging DVJ325BF, DVJ325BFS (Fig. D)
Place the appliance onto the charging base (7) and plug
u
into the electrical outlet.
Switch the electrical outlet on. The LED charging indicator
u
(B) will illuminate.
Charging DVJ215J, DVJ315J, DVJ320J,
DVJ325J (Fig. D1)
Place the charger (9) into the charging port at the rear of
u
the handle (2) and plug into the electrical outlet.
Switch the electrical outlet on. The LED charging indicator
u
(B) will illuminate.
Multi LED Display - DVJ325BF, DVJ325BFS
A
B
C
A. Filter sensor
Whenever a ilter is Blocked and needs cleaning, the red
ilter LED (A) in the handle will illuminate.
(Original instructions)
Clean ine dust from ilter (See section on 'cleaning ilters'
in this manual).
B. LED Charging display
The charging display LED (B) will illuminate when the unit
is charging and will indicate (lash) when further charging
is required.
C. BOOST mode
LED (C)
Illuminates when the appliance is in BOOST mode.
Dual LED Display - DVJ215J, DVJ 315J,
DVJ320J, DVJ325J
B
C
B. LED Charging display
Battery icon is illuminated when appliance is switched on
and will lash when the battery is almost depleted
charging. It will also lash during charging (See LED
pattern chart in this manual).
C. BOOST mode
Illuminates when the appliance is in BOOST mode.
ENGLISH
7