Functions; Start Stop - Junghans W 615.97 Manual De Instrucciones

to run with the accuracy of a quartz timepiece, using the internal time
memory. As soon as the signal is picked up again successfully, your watch is
synchronised and the reception indicator is reset to '0'.
Recommendation: To ensure the best possible conditions for night-time recep-
tion of the synchronisation signal, you should ideally not wear your watch at
night and you should, if possible, not put it down near to electrical appliances,
mobile or cordless phones.

4. Functions

The Junghans Multi-frequency Alarm Chronograph features a variety of func-
tions. These are indicated in the two areas of the LCD display and are operated
via the four buttons on the left and right of the watch case.
40
RESET ON-OFF
Functions
nd
Press for 3 seconds to lock/unlock 2 time
Press for 3 seconds to switch to Set mode
Press for 3 seconds to lock/unlock 1 st time
Reset chronograph when stopped
Alarm on/off
Timer on/off
MODE
Functions
Display mode (2 nd time)
Reception indicator / Set mode
Analogue time (1 st time)
Chronograph
Alarm
Timer
Digital second display (only in Low Batt mode)
Winder lock:
On the winder of your radio-controlled watch there is a black line that acts as
a marker. If this line is aligned as an extension of the 3 o'clock position, all of the
watch button functions are enabled. If the mark is not visible as an extension
of the 3 o'clock position, the button functions are disabled.
SET+

START STOP

Functions
nd
2 time (display) + 30 minutes
Press 3 seconds for transmitter call /
Set+ adjustment
1 st time analogue time + 1 hour
Start / stop chronograph
Alarm time + 1 minute
Timer time + 1 second
SET–
SPLIT
Functions
2 nd time (display) – 30 minutes
Year output / Set adjustment
st
1 time analogue time – 1 hour
Chrono split
Alarm time – 1 minute
Timer – 1 second
41