Ideal Distance Of The Mark From The Hole Center; Rated Voltage; Using Extension Cords - Hilti DD 150-U Manual De Instrucciones Original

Weight of the drill stand with combination base plate and
carriage
Dimensions, diamond core drilling machine (L×W×H)
Dimensions, drill stand (L×W×H)
Permissible water supply pressure
Rated speed under no load
Protection class
4.2

Ideal distance of the mark from the hole center

Anchor base plate
Vacuum base plate
Combination base plate
4.3

Rated voltage

The product is available with various voltage ratings. Please refer to your product's type identification
plate for details of its voltage and input power ratings.
Rated voltage 100 V
Rated current
15 A
input
AC frequency 50/60 Hz 50/60 Hz 50/60 Hz
4.4

Using extension cords

Use only extension cords of a type approved for the application and with conductors of adequate gauge.
Recommended minimum conductor cross-sections and maximum power cord lengths:
Conductor cross-
section →
↓ Mains (AC) voltage
100 V
110 V
127 V
220 V
230 V
240 V
*434950*
Printed: 09.08.2019 | Doc-Nr: PUB / 5069547 / 000 / 06
1st gear
2nd gear
3rd gear
110 V 110 V
GB TW
16 A 15 A
1.5 mm² 2.5 mm²
Not
recommended recommended
Not
recommended
Not
recommended
35 m
40 m
40 m
434950
DD 150-U
13.3 kg
20.3 in x 5.1 in x 6.3 in
(516 mm x 129 mm x 159 mm)
24.0 in x 9.8 in x 37.5 in
(610 mm x 250 mm x 952 mm)
≤ 6 bar
840 /min
1,640 /min
3,070 /min
Protection class I (earthed)
10.6 in
(270 mm)
11.4 in
(290 mm)
11.4 in
(290 mm)
120 V 127 V 220 V
19.5 A 18.5 A 10 A
60 Hz 50/60 Hz 50/60 Hz 50/60 Hz 50/60 Hz
3.5 mm²
Not 25 m
15 m Not
recommended
20 m Not
recommended
65 m Not
recommended
70 m Not
recommended
70 m Not
recommended
230 V 240 V
10.3 A 9.9 A
4.0 mm²
Not
recommended
30 m
35 m
105 m
110 m
110 m
English 9