Amann Girrbach Ceramill motion Modo De Empleo página 34

I N S T A L L A T I O N
▷ Insert the selected blank into the holder in the
Ceramill Motion. The high/thick side of the blank
E N
must face the spindle.
Fig. 7
▷ Fasten the blank using four screws and washers.
NOTE:
Do not damage the blank!
▷ Do not overtighten the screws! Avoid mechan-
ical stress!
▷ Tighten the screws with the Allen key provided.
Fig. 8
34
Inserting a blank
Tightening a blank
▷ Shut the milling machine door.
▷ Switch the milling machine on via the main
switch [4].
▷ Switch the PC on.
▷ Start the Ceramill Motion Software.
When the software is started, a machine initiali-
sation takes place.
If the milling machine is not detected:
▷ Restart the PC.