Fitting The Installation Kit - Graf ANAEROBIX Manual De Instrucciones

4. Fitting the installation kit

1. Upper half-shell
Drill inlet and outlet on opposite sides with DN
110 core drill (diameter 124 mm).
Upper half-shell
3.
Deburr hole. Insert DN 110 edge seal. The drain
must run from the inside out.
5.
Fit T-piece with reducer on perforated filter pipe.
4. Fitting the installation kit
Drill open the two DN 200 fittings with DN 160 core
drill (diameter 175 mm) or cut open with a jigsaw.
2 x
Insert 160/110 reducer into DN 160 T-piece.
Fit 90° bend, DN 110 on filter pipe.
16 / 44
2.
Upper half-shell
4.
6.