Icon Explanations; Controller Operation - Mitsubishi Electric PAR-30MAA Manual De Instrucciones

Not all functions are available on all models of indoor units.

Icon explanations

Controller operation

Timer
The administrator password must be entered on the password
input screen to change settings. There is no settings that can skip
P
this process.
Enter administrator password
Select:
Cursor
F1 F2
Indicates settings that can be
changed only while the units
ON
are in operation.
Indicates settings that can be
changed only while the units
are operated in the Cool,
Heat, or Auto mode.
Service
Test run
Input maintenance info.
Function setting
Lossnay (City Multi only)
Check
Self check
Maintenance password
Remote controller check
Timer
F1 : Press to move the cursor left.
F2 : Press to move the cursor right.
F3 : Press to decrease the value by 1.
F4 : Press to increase the value by 1.
*Changes cannot be made unless the
F3 F4
P
correct password is entered.
Indicates settings that can be changed
only while the units are not in operation.
OFF
Indicates functions that are not available
when the buttons are locked or the
system is centrally controlled.
Refer to the indoor unit Installation
Manual.
Refer to the indoor unit Installation
Manual.
Refer to the Installation Manual.
Refer to the Installation Manual.
Refer to the indoor unit Installation
Manual.
Refer to the Installation Manual.
Refer to the Installation Manual.
Refer to the Installation Manual.
The table below
summarizes the square
icons used in this manual.
Main
Indicates
settings that
can be made
only from the
main remote
controller.
11