Stainless Steel Panel Kit Installation Requirements; Custom Wood Overlay Panel Requirements - JENN-AIR JB36NXFXLE Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Standard Integrated Grille Installation—Full Product View
Stainless Steel Panel Kit
Installation Requirements
See the "36" Single Door Models" or the "36" or 42" French Door
Models" section to see the panel kit options available for your
model.
IMPORTANT:
A panel kit installation can be achieved with either a 24"
(60.9 cm) or 25" (63.5 cm) deep opening.
Refer to the instructions provided with the Stainless Steel
Door Panel Kit to install the door panels and standard grille.
The grille panel height, shown in the "Panel Kit Installation—
Side View" graphic, allows for an air gap critical to refrigerator
performance.
Panel Kit Installation—Side View
A. Soffit
B. Airflow
C
C. Airflow
A
B
C
D
C. Grille panel
D. Door panel
Panel Kit Installation—Full Product View
Custom Wood Overlay Panel
Requirements
Custom wood overlay panels allow you to blend the exterior of
your refrigerator into the overall kitchen décor and to use custom
handles for additional design flexibility.
In some cases, your cabinet manufacturer may choose to work
with one panel routed for the different dimensions. Follow these
panel dimension and placement instructions to be sure that the
custom wood overlay panels will fit properly.
IMPORTANT:
For 36" (91.4 cm) Single Door models, the refrigerator door
wood overlay panel cannot exceed 60 lbs (27.2 kg) and the
freezer drawer overlay panel cannot exceed 25 lbs (11.3 kg).
For 36" French Door models, the refrigerator door wood
overlay panel cannot exceed 38 lbs (17.2 kg) and the freezer
drawer overly panel cannot exceed 25 lbs (11.3 kg).
For 42" (106.7 cm) French Door models, the refrigerator door
wood overlay panel cannot exceed 38 lbs (17.2 kg) and the
freezer drawer overlay panel cannot exceed 30 lbs (13.6 kg).
The weight of the top grille wood overlay panel cannot exceed
7 lbs (3.2 kg) for both models.
The required thickness for all panels is ³⁄₄" (1.91 cm).
This installation does not require filler or backer panels.
15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Jb36nxfxreJpk36bnxepsJf36nxfxdeJf42nxfxdeJpk42fnxeps

Tabla de contenido