Install Door Panels - JENN-AIR JB36NXFXLE Manual De Instrucciones

Remove Trim Pieces
1. Remove all tape and door bracing from the refrigerator and
freezer doors.
2. Open the refrigerator and freezer doors.
3. Remove the hinge cover trim pieces from the top and bottom
of the door to expose the holes in the hinges.
NOTES:
It is not necessary to remove the hinge side trims as they
will not interfere with the installation.
Leave the freezer drawer trims in place for installation.
A. Hinge cover pieces
B. Door adjustment pin cover
Install Drawer Panel
1. Align the slots in the door panel brackets, located on each
side of the drawer panel, with the holes that go through the
drawer trim and into the drawer.
2. Using Phillips-head flat screws (provided with refrigerator),
attach the brackets to the drawer.
3. Move the drawer panel up and down or from side to side to
align. Do not fully tighten the screws.
A
B
A. Drawer overlay panel
B. Drawer panel bracket
A
B
A

Install Door Panels

IMPORTANT: Use the foam packaging to prop and hold the
door(s) open while installing a door panel.
1. Align the two shoulder washers, on the back of the door
panel, with the "J" slots on the side of the refrigerator door.
Slide the panel onto the door.
A
A. Shoulder washer and hex-head pointed screw
B. "J" slot
2. Lower the panel bracket down onto the adjustment pins at the
top of the door.
A. Door panel
B. Panel top bracket
3. French door models, repeat steps 1 through 2 to install the
second door panel.
4. Using slotted hex-head screws (provided with refrigerator),
attach the mounting bracket (factory installed), located at the
bottom of the refrigerator and freezer doors, to the respective
door panels. Do not fully tighten the screw.
A
A. Bottom hinge
B. Mounting bracket
B
A B
C
C. Adjustment pins
B
25